![]() ![]() The result will be an increase in volume. !By leaving the master send on and engaging a Mixbus send, you may hear both audio feeds simultaneously. In this case, you have a single volume control (fader), EQ, compressor, and series of plugins that can be applied to the drum group overall. To use the mixbus send as a “group bus”, you will typically click the Bus assignment button, and leave the bus send knob at the default position of “unity” or 0dB.įor example, you might assign all of the “drum” tracks to mixbus #4, and name it “Drum Bus”. the fader has effect on the mixbus send level. Note that although the mixbus send has its own pan control, it is still sent post channel fader i.e. To turn off dual concentric mode simply double click on the knob while holding down the shift key. To adjust the pan, click and hold on the knob while holding the shift key down and move the mouse. As before, to adjust the level click and hold on the knob and move the mouse up or down. A small indicator will appear at the top of the knob indicating the pan position. To place a mixbus send into dual-concentric mode, hold the shift key down and double-click on the knob. In dual-concentric mode each mixbus send has its own pan control as well as its level control, and is no longer controlled by the master bus pan knob. If it is desired for the panning to a mixbus to be different from the master pan, the mixbus send can be put into dual-concentric mode. By default a channel is panned to a mixbus according to the position of the master bus pan knob. If the bus send is OFF, double clicking will also turn it ON.Īs all mix buses are stereo, panning the channel strip signal into the selected mix buses might be desired. Double clicking on the knob will restore it to the default 0dB position at its centre. To adjust the level of the bus send click and hold on the knob, moving the mouse up or down will turn the knob in the desired direction. All of the lit buttons have slightly different colours to help distinguish them. A lighted button will indicate an active assign to the mixbus. To assign to a mix bus, click on the button or the label for the desired mix bus. Latency compensation is provided in the mixer so that these signals will reach the master bus with coherent timing. * From an input channel, you may send to any combination of the multiple mixbuses and/or master bus simultaneously. Master bus, with on/off indicator and stereo pan control.In the image above, mixbus send “2” is in “dual-concentric mode”, which allows the send to be panned separately from the master bus pan.In the image above, mixbus send “1” is enabled. ![]() Mixbus sends occur at the end of the processing redirect list, and therefore are post-fader and post-pan ( by default, they follow the master bus pan setting ).Each mixbus send has an on/off indicator, and a level control.12 stereo mixbus “sends” which correspond to the 12 available mixbus master strips in the mixer window.Mixbus32C provides these bus send features from each input strip: The picture below shows the Mixbus32C send controls: Appendix C: Videos (Training and Tutorial)Ĭlick the “Sends” switcher on an input strip to expose the Mixbus Send knobs:.AVL Drumkits: Black Pearl and Red Zeppelin.Presonus Faderport, Faderport8 and Faderport16.Mackie MCU-compatible fader controllers.Scrolling and Zooming in the Editor Window.Operational Differences from Other DAWs.Differences between Mixbus and Mixbus 32C.About This Manual (online version and PDF download).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |